Hyppää sisältöön
    • Suomeksi
    • In English
  • Suomeksi
  • In English
  • Kirjaudu
Näytä aineisto 
  •   Etusivu
  • 3. UTUCris-artikkelit
  • Rinnakkaistallenteet
  • Näytä aineisto
  •   Etusivu
  • 3. UTUCris-artikkelit
  • Rinnakkaistallenteet
  • Näytä aineisto
JavaScript is disabled for your browser. Some features of this site may not work without it.

Continuous synthesis of menthol from citronellal and citral over Ni-beta-zeolite-sepiolite composite catalyst

Simakova Irina; Mäki-Arvela Päivi; Martinez-Klimov Mark; Muller Joseph; Vajglova Zuzana; Peurla Markus; Eränen Kari; Murzin Dimitry Yu.

Continuous synthesis of menthol from citronellal and citral over Ni-beta-zeolite-sepiolite composite catalyst

Simakova Irina
Mäki-Arvela Päivi
Martinez-Klimov Mark
Muller Joseph
Vajglova Zuzana
Peurla Markus
Eränen Kari
Murzin Dimitry Yu.
Katso/Avaa
1-s2.0-S0926860X22001090-main.pdf (4.617Mb)
Lataukset: 

Elsevier B.V.
doi:10.1016/j.apcata.2022.118586
URI
https://doi.org/10.1016/j.apcata.2022.118586
Näytä kaikki kuvailutiedot
Julkaisun pysyvä osoite on:
https://urn.fi/URN:NBN:fi-fe2022081154656
Tiivistelmä

One-pot continuous synthesis of menthols both from citronellal and citral was investigated over 5 wt% Ni supported on H-Beta-38-sepiolite composite catalyst at 60–70 °C under 10–29 bar hydrogen pressure. A relatively high menthols yield of 53% and 49% and stereoselectivity to menthol of 71–76% and 72–74% were obtained from citronellal and citral respectively at the contact time 4.2 min, 70 °C and 20 bar. Citral conversion noticeably decreased with time-on-stream under 10 and 15 bar of hydrogen pressure accompanied by accumulation of citronellal, the primary hydrogenation product of citral, practically not affecting selectivity to menthol. A substantial amount of defuctionalization products observed during citral conversion, especially at the beginning of the reaction (ca. 1 h), indicated that all intermediates could contribute to formation of menthanes. Ni/H-Beta-38-sepiolite composite material prepared by extrusion was characterized by TEM, SEM, XPS, XRD, ICP-OES, N2 physisorption and FTIR techniques to

Kokoelmat
  • Rinnakkaistallenteet [27094]

Turun yliopiston kirjasto | Turun yliopisto
julkaisut@utu.fi | Tietosuoja | Saavutettavuusseloste
 

 

Tämä kokoelma

JulkaisuajatTekijätNimekkeetAsiasanatTiedekuntaLaitosOppiaineYhteisöt ja kokoelmat

Omat tiedot

Kirjaudu sisäänRekisteröidy

Turun yliopiston kirjasto | Turun yliopisto
julkaisut@utu.fi | Tietosuoja | Saavutettavuusseloste