Hyppää sisältöön
    • Suomeksi
    • In English
  • Suomeksi
  • In English
  • Kirjaudu
Näytä aineisto 
  •   Etusivu
  • 3. UTUCris-artikkelit
  • Rinnakkaistallenteet
  • Näytä aineisto
  •   Etusivu
  • 3. UTUCris-artikkelit
  • Rinnakkaistallenteet
  • Näytä aineisto
JavaScript is disabled for your browser. Some features of this site may not work without it.

The physicochemical and catalytic properties of clay extrudates in cyclization of citronellal

Simakova Irina L.; Vajglová Zuzana; Peurla Markus; Eränen Kari; Murzin Dmitry Y.; Mäki-Arvela Päivi; Kumar Narendra; Efimov Alexander; Hupa Leena; Tolvanen Stiina; Peltonen Jouko

The physicochemical and catalytic properties of clay extrudates in cyclization of citronellal

Simakova Irina L.
Vajglová Zuzana
Peurla Markus
Eränen Kari
Murzin Dmitry Y.
Mäki-Arvela Päivi
Kumar Narendra
Efimov Alexander
Hupa Leena
Tolvanen Stiina
Peltonen Jouko
Katso/Avaa
1-s2.0-S0926860X21004403-main.pdf (2.958Mb)
Lataukset: 

Elsevier B.V.
doi:10.1016/j.apcata.2021.118426
URI
https://www.sciencedirect.com/science/article/pii/S0926860X21004403
Näytä kaikki kuvailutiedot
Julkaisun pysyvä osoite on:
https://urn.fi/URN:NBN:fi-fe2022081154733
Tiivistelmä

Four clay materials, namely, bentonite, bleaching earth, attapulgite and sepiolite, were shaped into the cylindrical body by extrusion. Clays were characterized in depth by TEM, SEM-EDX, N2 physisorption, pyridine FTIR, pH measurements, contact angle measurements, 27Al MAS NMR, and the crush test. Catalytic properties were investigated in the citronellal cyclization as a model reaction. The reaction was performed in the trickle-bed reactor at 70 °C, 10 bar of Ar with 0.086 M initial citronellal concentration in cyclohexane. The best results were obtained over attapulgite with isopulegols yield of 24% and stereoselectivity to the desired isopulegol isomer of 61%. Attapulgite had the highest meso-to-micropore volume ratio, the highest basicity, a low Brønsted-to-Lewis acid sites ratio, and the lowest amount of Brønsted acid sites compared to other extrudates. In addition, same clay exhibited the highest mechanical strength of extrudates.

Kokoelmat
  • Rinnakkaistallenteet [19207]

Turun yliopiston kirjasto | Turun yliopisto
julkaisut@utu.fi | Tietosuoja | Saavutettavuusseloste
 

 

Tämä kokoelma

JulkaisuajatTekijätNimekkeetAsiasanatTiedekuntaLaitosOppiaineYhteisöt ja kokoelmat

Omat tiedot

Kirjaudu sisäänRekisteröidy

Turun yliopiston kirjasto | Turun yliopisto
julkaisut@utu.fi | Tietosuoja | Saavutettavuusseloste